催化学报

催化学报 ›› 2017, Vol. 38 ›› Issue (8): 1322-1329.

• 论文 • 上一篇    下一篇

负载型Pd/SnO2催化剂低温催化甲烷燃烧

赵振阳, 王博伟, 马健, 詹望成, 王丽, 郭杨龙, 郭耘, 卢冠忠   

  1. 华东理工大学化学与分子工程学院工业催化研究所先进材料重点实验室, 上海 200237
  • 收稿日期:2017-03-26 修回日期:2017-05-18 出版日期:2017-08-18 发布日期:2017-08-04
  • 通讯作者: 王丽, 郭耘
  • 基金资助:

    国家高技术研究发展计划（2015AA034603）；国家重点研发计划（2016YFC0204300）；国家自然科学基金（21171055，21333003，21571061）；上海市曙光计划（12SG29）；上海市科委（15DZ1205305）.

Catalytic combustion of methane over Pd/SnO2 catalysts

Zhenyang Zhao, Bowei Wang, Jian Ma, Wangcheng Zhan, Li Wang, Yanglong Guo, Yun Guo, Guanzhong Lu   

  1. Key Laboratory for Advanced Materials and Research Institute of Industrial Catalysis, School of Chemistry and Molecular Engineering, East China University of Science and Technology, Shanghai 200237, China
  • Received:2017-03-26 Revised:2017-05-18 Online:2017-08-18 Published:2017-08-04
  • Supported by:

    This work was supported by the National High Technology Research and Development Program of China (2015AA034603), the National Key Research and Development Program of China (2016YFC0204300), the National Natural Science Foundation of China (21171055, 21333003, 21571061), the "Shu Guang" Project of the Shanghai Municipal Education Commission (12SG29), and the Commission of Science and Technology of Shanghai Municipality (15DZ1205305).

PDF

903

摘要：

天然气储量巨大，被广泛应用于发电和工业窑炉等.甲烷作为天然气中最主要的成分，是氢碳比最高的碳氢化合物，其温室效应显著.因此，不完全燃烧所引起的CH4排放，不仅导致能源浪费，同时也可造成环境污染.与传统火焰燃烧相比，CH4催化燃烧具有更高的燃烧效率，并可显著地减少大气污染物（CO，NOx和未完全燃烧的烃类）的排放.
贵金属Pd催化剂对CH4催化燃烧表现出优异的催化性能，其中Pd颗粒的尺寸、Pd的化学状态、载体性质及其与Pd之间的相互作用等对其活性有显著影响.本文以不同温度（600，800，1000和1200℃）焙烧所得SnO2为载体，通过等体积浸渍法制备了Pd/SnO2催化剂，研究了SnO2焙烧温度对CH4催化燃烧性能的影响.结果表明，所制备的SnO2均为锐钛矿结构，并且随着SnO2焙烧温度的升高，晶型愈加完美，晶粒尺寸显著增大.催化剂中引入的Pd以高分散形式存在，CH4催化燃烧反应活性随着载体SnO2焙烧温度的升高而显著提高，其中Pd/SnO2（1200）表现出最高的CH4燃烧活性，起燃温度和最低全转化温度分别为265和390℃.在反应温度为300℃时，Pd/SnO2（1200）上甲烷的反应速率是Pd/SnO2（600）的36倍.XPS等结果表明，随着SnO2焙烧温度的升高，Pd的化学状态也有所差异：对于低温焙烧的SnO2（< 800℃），Pd以Pd4+的形式进入到SnO2晶格内；随着焙烧温度的升高（>1000℃），Pd以Pd2+物种的形式存在于载体表面.结合活性评价结果推测，Pd的化学状态可能并非是影响催化剂活性的最关键因素.TEM等结果表明，Pd/SnO2（1000）上PdO的（101）晶面与载体SnO2的（101）晶面相近，分别为0.2641 nm和0.2638 nm.O2-TPD和CH4-TPR结果表明，Pd/SnO2（1200）催化剂上单位Pd原子上O2的脱附量是Pd/SnO2（600）的3倍，单位Pd原子上CH4的消耗量比催化剂Pd/SnO2（600）高出45%.因此，PdO和SnO2在构型上存在的晶面匹配可提高催化剂对O2的活化能力.
综上所述，SnO2和贵金属之间的晶格匹配有利于氧在Pd-SnO2界面的活化，同时载体SnO2中的晶格氧亦可以通过“氧反溢流机理”补充到表面PdO/Pd上，从而增强催化剂对O2的吸附和活化能力，并提高CH4催化燃烧反应性能.升高SnO2的焙烧温度可强化SnO2和贵金属之间的晶格匹配，从而使催化剂活性随着SnO2焙烧温度升高而增大.

关键词: 甲烷燃烧, 钯, 二氧化锡, 晶面匹配, 氧活化

Abstract:

SnO2-supported Pd catalysts were prepared and the effects of the support calcination tempera-ture on the subsequent catalytic activity during methane combustion were investigated. The physicochemical properties of the Pd/SnO2 were characterized by X-ray diffraction, high-resolution transmission electron microscopy, X-ray photoelectron spectroscopy, oxygen temperature-programmed desorption and CH4 temperature-programmed surface reaction. Only crystalline Pd species were found on the catalysts fabricated from the supports calcined above 800℃. It was also determined that lattice geometry matching between PdO and SnO2 in the catalyst made with a support calcined at 1200℃ facilitated oxygen activation from SnO2 to vacant oxygen sites on the PdO/Pd surface via the back-spillover of oxygen. This effect in turn enhanced the catalytic combustion process. The activity of this material was clearly increased compared with the catalysts that did not exhibit lattice matching between the PdO and support.

Key words: Methane combustion, Palladium, Tin oxide, Lattice match, Oxygen activation